SAPFIR-3D 2018 R2 Release Notes

Structural engineering software LIRALAND Group

Last updated: 6 December, 2018

SAPFIR-Structures

  • Added: rotation angle for the object remaines the same when the object type is changed – transforming wall into column.
Transforming wall into column (rotation angle is remained the same)
Transforming wall into column (rotation angle is remained the same)

  • Enhanced import of models in IFC format:
    • enhanced: identification of geometric location of fillings in openings and stairs;
    • integrity of model is saved during the import from Renga.
  • Improved option to edit analytical model of stairs – thicknesses of plates that simulate staircases and landing.
Edit stairs – thicknesses of plates that simulate staircases and landing
Edit stairs – thicknesses of plates that simulate staircases and landing


  • Enhanced: option to copy windows with the base point and with the commands Paste to selected storeys, Paste selected to storey.
  • Enhanced: option to edit (in groups) fillings in openings.
  • Advanced check of model, namely check for coincidence of surfaces.
  • During import of floor plans in DXF format, in identification of steel elements (columns, beams), in parameters of these elements, material 'Steel structures' will be defined automatically.
  • Corrected error that caused renumeration of slab segments after the 'Cut off by line' command and, as a results, caused re-assignment of boundary conditions assigned to these segments.
Boundary conditions on slab edge
Boundary conditions on slab edge
  • Corrected error that caused occurrence of duplicate piles when you selected the pile and press ENTER.
  • Restored functionality of the 'Filter by parameters' dialog box when you work with beam sections.
Filter by parameters for beams
Filter by parameters for beams
  • Enhanced rubustness of the system when saving SAPFIR objects to the library, corrected error in defining the snap point of the saved objects.
Save selected fragment to the library for further usage
Save selected fragment to the library for further usage

Generator

  • For nodes of windows and doors, new option to generate objects along line. Width of opening is determined automatically along the length of line.
Generate windows and doors along line
Generate windows and doors along line
  • Columns may be generated by points of intersection of grid lines at storeys where elevations are below zero (below location of grid lines).
  • For separate objects generated with node, it is possible to define and save parameters that may differ from properties of node.
  • Enhanced option to select nodes included into Group of nodes.

LARGE PANEL BUILDINGS

  • Enhanced option to generate platform and contact joints with eccentricity.


Last updated: 6 December, 2018

Comments

Write

Version History
LIRA-FEM software