liraland.com [Topic: Adjusting height of a column in SAPFIR 2015] http://www.liraland.com New posts in Adjusting height of a column in SAPFIR 2015 of forum at liraland.com [www.liraland.com] en http://backend.userland.com/rss2 Sat, 27 Jun 2026 04:03:18 +0300 Adjusting height of a column in SAPFIR 2015 Adjusting height of a column in SAPFIR 2015 in forum General Discussion.

Hi, aakhvlediani97!

You can`t change height of column because it is connected to the storey height by default. If the storey height is 3m, then a column height is 3m. You can change either the storey height (see pic.1) or you can disconnect column from the storey height. To do this, you should specify the top level snap for column – From storey bottom (see pic.2). After that, specify the real height of the column inside the edit box.




Dec 7, 2018 12:49:11, Александра.]]> http://www.liraland.com/forum/messages/forum3/topic2287/message15769/ http://www.liraland.com/forum/messages/forum3/topic2287/message15769/ Thu, 07 Dec 2017 12:49:11 +0200 General Discussion Adjusting height of a column in SAPFIR 2015 Adjusting height of a column in SAPFIR 2015 in forum General Discussion.
Hello Liraland community,

I am quite new to this software and very much unfamiliar. I am currently using the non-commercial version of Lira SAPFIR. As basic as it may seem, I can't figure out how to change the height of a column and it always defaults 3 meters when I am designing a structure. Can you help me edit this parameter?

Thanks.
Dec 6, 2018 22:00:39, aakhvlediani97.]]> http://www.liraland.com/forum/messages/forum3/topic2287/message15768/ http://www.liraland.com/forum/messages/forum3/topic2287/message15768/ Wed, 06 Dec 2017 22:00:39 +0200 General Discussion